Heat flow sensor | English abbreviation for car fog lights

『heat flow sensor』Related information(flow rotameter|digital flow meter|balo meter|hydraulic flow meter|volumetric meter|positive displacement meter|pitot tube flow meter|displacement meter|cfm meter|variable area flow meter|inline flow meter|differential pressure flow meter|calibrated flow meter|velocity meter|paddle wheel flow meter|oval gear flow meter|anemometer hvac|multiphase flow meter|doppler flow meter|thorpe tube flowmeter|heat flow meter)

1.急求英文在线翻译,不要翻译工具的,最好可以人工翻译,语法还有句子通顺...

4 Requirements 要求4.1 Design requirements 设计要求When designing the heating system, the heat meter supplier"s installation instructions shall be followed.设计加热系统时，温度传感器的供应商提纳空供以下安装说明。NOTE For DN 25 and smaller, it is possible to use short probes. To achieve good temperature sensitivity, probes should be installed without temperature pockets. Temperature pockets should only be used when required for safety reasons.注意直径是25 和更小的，要使用短探针。为达到温度灵敏度最好效果，探针在安装时去掉温度包。温度包只有在达到安全条件时才被使用

4.2 Installation requirements 安装要求The heat meter shall be installed in accordance with the supplier"s instructions.安装温度传感器参考供应商提供的说明。Before installation, the circuit into which the flow sensor is to be installed shall be thoroughly flushed to remove debris. The strainer, where fitted, shall be cleaned.开始安装前，确定流量传感器的电路已被安装，彻底移除安装碎片。固定过滤器，确保已被打扫洞轮瞎。The heat meter shall be protected from the risk of damage by shock and vibration induced by the surroundings at the place of installation.The heat meter shall not be subjected to undue stresses caused by pipes and fittings.温度传感器避免受安装地点环境引起的振动和由震动造成的损害。温度传感器要避免因管道和装置引起的不适当重压。The pipe lines of the heating system up and downstream of the heat meter shall be adequately anchored.安装在温度传感器上下部分的加热系统管线要被固定牢固。Heat meters designed to operate from an AC mains supply shall be wired in accordance with wiring regulations applicable.温度传感器由AC交流电源供应，配备的电线符合电桐好线规章。The AC-mains power supply shall be secured against accidental interruption. However, circuit protection shall be incorporated according to the state of the art, to safely disconnect the device when electrical problems occur.AC电源供应一旦受突发事件中断，确保电源受保护。当电路故障发生时，安全拆开设置时，要提供与技术发展水平一致的电路保护。Measurement signal leads shall

not be laid directly along side other leads such as mains supply cables, low voltage supply cables and data communication cables and shall be independently supported. The separationbetween those groups shall not be less than 50 mm.信号测量线不要与其它线（如主电源线，低压线，数据传输线）直接安装在一起，它们是被独立安装的。这些线的安装间隔距离不小于50毫米。Mains and external signal cables longer than 10 m shall in areas where lightning is frequent be protected with an external lightning surge protection at the cable entrance to the building.主线和外部信号线超过10米的，在线进入大楼的入口处时设置避雷保护，避免雷击。Each signal lead between temperature sensors and calculator shall be one continuous length without joints.每一条连接温度传感器和计算器的信号线应是一条线，没有连接处。Signal circuits between parts of a heat meter shall be so installed as to deter unauthorized interference and disconnection.在温度传感器之间的信号线路被安装时，要确保不受其它信号干扰。Precautions shall be taken to prevent damage to the heat meter by unfavourable hydraulic conditions(cavitation, surging, water hammer).温度传感器要做预防措施来防止因水力条件（气穴，冲击，水击）引起的损害。When the installation of the heat meters is complete, it shall be inspected and approved by representatives of the competent authority in accordance with established procedures.温度传感器安装流程完成后，由主管当局代表根据规定程序检测，经核实批准使用。

2.汽车雾灯的英文缩写

汽车雾灯 Autofog lamp 汽车在雾、雪和大雨等恶劣气候条件下，或者清衫在烟尘弥漫的环境中行驶时，为了照亮前方道路圆汪，保障行车安全而必须采用前雾灯照明。近年来，在造型设计方面，橘正仔多将雾灯设置在前保险杠上。

3.请问日本专利"特开昭62-210330"怎么查询?

去日专局网站可以查的。查的时候，棚皮吵如果特开后面接的是四位数，那么直接把特开二字和-号忽略掉即可，这个四位数就是年份，后面六位数是需要，例如握简你这个专利查的时候直接填27，类型填A如果特开后面接的是“平”或者“昭”+一位数或者两位数，那么就费点事了，这个平链侍和昭是日本的年号。如果是平，那么需要将这个数字加上1988，如果是昭需要加1925。举个例子，如果某日本专利公开号是特开平9-100463，那么你查的时候需要输入10463，类型一样填A；如果是特开昭55-100463，那么需要输入10463，类型也是A。

4.燕山大学过程装备与控制工程专业英语

“燕山大学过程装备与控制工程专业英语”对应的英文表述为“Process Equipment and Control Engineering (Yanshan U